With the upgrading of domestic production equipment, more and more customers choose the three-in-one servo feeder.In the use of the three-in-one servo feeder, in addition to routine maintenance, we must also carry out regular maintenance.Why and how to do regular maintenance, we will share with you here.
The three-in-one servo feeder will inevitably appear some wear and tear, failure and so on in the long time of use. The purpose of regular maintenance is to find the problem in advance, extend the service life, and avoid causing serious consequences.
What parts need regular maintenance? Let's take a look:
1. Whether there is grease for various drive gears, gear shafts, inlet width guides and other parts, if not enough, brush grease with a brush.The grease used should meet the specified viscosity and should not be mixed with different kinds of grease. Care should be taken not to mix with impurities and water, as the change of composition will cause the performance to be reduced. Clean grease should be used.
2. The driving chain of the uncoiler and the tension of the driving belt of the feeder are corrected.Inspect the chain and belt for wear and tear, and replace them if any.
3. Many oil nozzles of the uncoiler spindle need regular refueling.
4. Check whether there is air leakage in the air distribution pipe, and replace it in time if there is
5. Dust and sundries on the work roll and main operating panel need to be stopped regularly for cleaning.
6. Regularly check the thickness of the brake belt. If the thickness changes to 2mm, a new brake belt shall be replaced.
For our production safety and the production continuity, we must strictly observe operating instructions and do daily and regular maintenance, if suddenly in the process of production equipment downtime, the operator must be calm, if the devices are not familiar with, don't understand the case, the failure of must not be disposed of without authorization, please notify the professional maintenance personnel or inform the manufacturer to help solve, troubleshooting as soon as possible.If the fault is the cause of operation, the operator should learn experience in time to avoid making the same mistake next time.
