-
How to Set Thickness on a 3 In 1 Straightener Feeder
Sep. 01, 2026
To set thickness on a 3 In 1 Straightener Feeder, I first measure the actual coil material, then adjust the thickness dial and straightening-roll clearance to match that measurement. I synchronize both sides, set feed-roll pressure, confirm the press feed height, inch the strip at low speed, and relock every adjustment before production.
-
How Integrated Feeders Improve Workshop Layout
Aug. 26, 2026
Integrated feeders improve workshop layout by reducing floor-space congestion, shortening material-flow paths, and increasing machine utilization. Instead of positioning a feeder as a separate unit beside production equipment, I treat the feeder, coil storage, straightener, press, controls, and operator access as one coordinated system. A practical example is a stamping cell in which a decoiler,
-
How to Match Coil Feeder Model with Sheet Thickness
Aug. 26, 2026
To match a coil feeder model with sheet thickness, I use five checks: confirm thickness and material strength, verify width and coil data, calculate feed pitch and press speed, check feeder and straightener capacity, then confirm press-interface compatibility. I never select a feeder from thickness alone because width, yield strength, coil weight, coil diameter, grip force, and production rate
-
How to Improve Sheet Length Accuracy in CTL Production
Aug. 26, 2026
I improve sheet length accuracy in CTL production by controlling the complete material path rather than adjusting the shear alone. The most effective sequence is to calibrate the measurement system, eliminate feed-roll slip, stabilize straightener and feeder settings, synchronize shear timing, match line speed to material behavior, maintain wear components, and verify finished sheets with
-
How to Improve the Cutting Quality of Steel Coil Slitting Machine and Reduce Burrs
Aug. 26, 2026
Burrs are primarily reduced by matching knife clearance and overlap to steel thickness and grade, using sharp correctly ground knives, verifying arbor alignment and shaft runout, stabilizing tension and tracking, and measuring a test strip before full production. I recommend starting with material inspection, then checking knife condition, clearance, overlap, tension, speed, and winding stability
-
NC Feeder V1_20260710 -Dual-Mode Interface Now Available
Jul. 15, 2026
NC Feeder V1_20260710 -Dual-Mode Interface Now Available
-
Operation and Maintenance Guide for Uncoiler Machine
Jun. 05, 2026
uncoiler machine, uncoiler operation, uncoiler maintenance, uncoiler usage guide, uncoiler care tips
-
Servo feeder vs mechanical feeder: accuracy comparison
May. 14, 2026
Explore a detailed comparison of servo feeder vs mechanical feeder accuracy. Learn how each system performs in precision feeding, efficiency, and production stability, and discover which is best for modern stamping applications.
-
Guide to Choose a 3 in 1 Straightener Feeder
May. 13, 2026
Learn how to choose a 3 in 1 straightener feeder for press line automation. Discover key features, selection tips, applications, and expert buying guide.
