NC Feeder V1_20260710 -Dual-Mode Interface Now Available

We’ve released firmware V1_20260710 for all NC servo feeders. Fully backward compatible runs on every existing device.

What’s new: Two switchable HMI modes on the same screen (no extra hardware).

l Standard Mode - full parameter set, but with a larger custom keypad (bigger buttons, clearer digits) to reduce mis-taps.

l Simplified Mode - shows only feed length, feed count, and speed with oversized buttons, large fonts, and a built-in simple keypad. No advanced menus, no clutter.

Who benefits:

Older operators - easier to read and press accurately.

New trainees - learn just 3 settings and start working in minutes.

Simple jobs - no scrolling through unused parameters, faster daily operation.

How to get it: Download the update package from our Support Center. Installation takes under 10 minutes.